The first design of the bucket sagged. It needed support on the bottom to keep it level. We added to forks under the bucket to keep it level and supported.
A claw attached to a motor was designed to grab the pizza, ice cream, and a rat, and to activate dispensers. Why wasn’t this used? The dispenser were built wrong so we had to take the claw off.
The controller was turned 180 degrees from the previous design, to distribute the weight better over the wheels.
After you take the "key" you can't change the robot or it will change the center of balance and the programs won't work the same.
Nathan
A claw attached to a motor was designed to grab the pizza, ice cream, and a rat, and to activate dispensers. Why wasn’t this used? The dispenser were built wrong so we had to take the claw off.
The controller was turned 180 degrees from the previous design, to distribute the weight better over the wheels.
After you take the "key" you can't change the robot or it will change the center of balance and the programs won't work the same.
Nathan
No comments:
Post a Comment